Which are the DNP commands modes supported by the M-7679 R-PAC?


 

Which are the DNP commands modes supported by the M-7679 R-PAC?

The M-7679 R-PAC supports Direct-Operate and Select-Before-Operate commands modes. Direct-Operate mode is used when the two-step control is not required. In this case, the command is sent by the Scada and once received by the M-7679 R-PAC it is executed in a single step. Select-Before-Operate requires a two-step process to complete the command. First, a Select instruction allows validating the command parameters. Once the validation is done, the real command will be sent and executed.

 

Previous When a DNP Binary Event occurs in the M-7679 R-PAC, is it time stamped?
Next Does the M-7679 allow programming all Front Panel LEDs?